Lubricants - HOMCOM A90-252V91 Instructions D'assemblage

Note: The running belt cannot be adjusted too tightly. This will pull the running belt, increase the
pressure of the front/rear drum, and damage the drum bearings, resulting is damage to the treadmill.
Only adjust the running belt so that it does not slip during operation.
5.2 Running belt alignment.
When you use a treadmill, the pressure on the running belt is unbalanced because the force of both feet is not the
same when running, causing the running belt to deviate from the centre. This deviation is normal, and when no one
is running on a running belt, it automatically returns to the centre. If your belt does not do this, you will need to run
the belt back to centre.
Run the treadmill without stepping onto it, and increase the speed to 6th gear, observe the distance from the left
and right-side bars:
● If left, use a hex wrench to rotate the left screw clockwise 1/4 turn.
● If right, use a hex wrench to rotate the right screw clockwise 1/4 turn.
● If the running belt is still not in the middle, repeat the above action until adjusted to the middle.
After adjusting the belt to the middle, adjust the speed to 6th gear, and observe the deviation of the running belt
and the smoothness of the run, if there is a deviation, repeat the adjustment step.
Warning! Do not over tighten the drum! This will result in permanent damage to the bearings
6

LUBRICANTS

Treadmills are oiled when they are shipped, but the lubricity of the treadmills is often checked to help keep the
treadmills at peak use. The treadmill must be lubricated after one year of use or 100 hours of operation.
After 30 hours or 30 days of use, in the treadmill stationary state, pull the starting belt from the side to reach as far as
possible to touch the table surface, if you feel touch the lubricant, do not need to add lubricant;(Use non-petroleum
lubricants).
How to add lubricant.
Please adhere to the following instructions carefully.
Open the side bar on the front left of the refuelling decorative cover. Insert the bottle into the opening to
measure the size, use a pair of scissors or art knife to cut off tip of the bottle to size. Place the bottle
into the hole and squeeze the bottle (as illustrated to refuel). Please ensure the oil bottle tip of the thin
rod is inserted correctly and securely into the fuel pipe on the platform and then pour oil into it.
!
~ 6 ~