Button Function; Maintenance Instructions - HOMCOM A90-252V91 Instructions D'assemblage

4

BUTTON FUNCTION

3.1 START/STOP
When the power is turned on, press the "START/STOP" button at any time to start the running of the treadmill.
Press the STOP button to stop the treadmill during exercise. Press and hold the STOP button to put the treadmill
into sleep mode and press any button to restart the machine.
3.2 "-" "+"
Use to adjust the speed of the treadmill after starting up. The adjustment range is 0.1km/h. When held for more
that two seconds, it will automatically increase or decrease the speed by 0.5km/h.
3.3 Standby
If the treadmill does not detect any input after being in the standby mode for more than 10 minutes, it will enter
into the energy-saving mode. During this time, there is no display on the screen. Pressing any button will exit
the standby mode.
5

MAINTENANCE INSTRUCTIONS

Proper maintenance keeps your treadmill in optimal condition, improper care and maintenance can result in an injury or
shorten the life of the treadmill.
Warning: Always unplug the treadmill before cleaning or maintaining the appliance!
1. Regularly remove dust to keep the parts clean.
2. After each use of the treadmill, use a clean towel or cloth to clean the meter and other parts with sweat and
debris. Please be careful not to splash water on any electrical components and under the running belt.
3. Please place your treadmill in a clean and dry environment, ensure the power is turned off and the power cable
has been unplugged.
4. To facilitate easy movement, the treadmill is equipped with wheels, please ensure you disconnect the power
supply and fold the body before moving.
5. Check and lock all parts of the treadmill frequently.
6. To maintain and extend the life of the treadmill, it is recommended that you rest the treadmill for 10 minutes after
30 minutes of continuous use.
7. The running belt has been adjusted before leaving the factory, but after use, the running belt will be stretched and
will deviate from the centre position, causing the running belt to rub the side bars and the rear cover and damage
it. It is normal for the running belt to be forced to stretch during use. After using the treadmill for a period, if the
running belt slips or is not smooth when using the treadmill, you can adjust the tightness of the running belt to
improve it, as indicated below
Running belt loose adjustment.
5.1
If the running belt is too loose, step off the treadmill, insert a hex wrench into the
adjustment hole of the left guard and rotate clockwise 1/4 turn, and then rotate
1/4 lap clockwise on the right foot. Pay particular attention when tightening the
belt and ensure both sides are adjusted synchronously, so that the running belt
can be tightened and will not deviate from the centre point. If the running belt is too
tight, adjust the left and right synchronisation counter clockwise.
plays the current running speed.
.
MAINTENANCE INSTRUCTIONS
~ 5 ~