Use The Call Back Features; Delete Stored Names And Numbers; Paging The Handset; Timer - Geemarc Ampli DECT300 Notice D'utilisation

USING THE PHONE

3 - USE THE CALL BACK FEATURES

You can display the last 5 numbers you dialed
- Press the key and scroll through the list by pressing the or
keys until you select the number you want.
- Press the key to dial the number.
: Exit
: Delete the displayed entry

4 - DELETE STORED NAMES AND NUMBERS

Only if you subscrided to the "Caller ID" service, otherwise the list will be
empty .
- Press the key.
- Select the desired number to delete by pressing the or key. Two
short beeps will be heard when you reach the end of the list.
- Press the key to delete the entry, a short beep will be heard .
- Do it again from step 2 for deleting other entries, otherwise exit on
pressing the key .

5 - PAGING THE HANDSET

If you wish to locate your handset on making it ring, simply follow the
instructions below ( if it is in a valid receiving area )
- Press the key on the base unit located on the base front side, all
the registered handsets paged will ring.
- Press the twice on the located handset to stop the paging mode.
Pressing the key on the base unit has the same effect.

6- TIMER

A timer will be displayed on the screen after starting the call. You can check
the call length by using this function.
15