10. Troubleshooting
10.1 Cat will not use the flap
It may take time for timid cats to learn how to use the cat flap - even if
they have used another cat flap before.
• First try using 'TRAINING MODE' (See Section 6).
• You may disable the energy saving mode so your cat will find it easier
to use the flap (although battery consumption is increased) as follows:
Press and hold the 'PROGRAM' button and within 3 seconds press and
release the 'SET' button. When the display flashes release the
'PROGRAM' button.
Press the '4 WAY' button to choose between:
+
= Energy saving mode OFF
+
= Energy saving mode ON
Press 'SET' to save setting.
10.2 Flap does not open in response to programmed I.D. Disc or microchip
• Check '4 WAY' lock is programmed to permit access in the chosen
direction.
• The energy saving circuitry may have been activated and will be shown
by a short flash on the red LED every 2 seconds. Do not move the flap
until the LED stops flashing.
• Check batteries are correctly orientated (Fig.3) and not in need of
replacement (See Section 7).
• Check the I.D. Disc is correctly fitted to cat's collar (See Section 5.2).
• If possible, try operation with another programmed I.D. Disc / microchip
to ascertain if there is a fault with a particular I.D. Disc / microchip.
• Check cat flap is mounted at correct height (See Fitting Instructions).
• If all else fails, remove batteries and wait a minimum of 5 minutes. Refit
batteries and then perform a 'FACTORY RESET' (See Section 9) before
reprogramming (See Section 3).
10.3 Flap has not fully closed
This problem may happen very occasionally and will normally self correct
within 30 minutes. If problem persists remove batteries for 5 minutes
before replacing when correct lock action should be resumed.
10.4 Difficulty in setting required functions
• Buttons need to be pressed firmly.
• Remember to press the 'SET' button after making any change to save
the setting.
10.5 Flap does not lock
• Check flap not in 'TRAINING MODE' (slowly flashing arrows).
• Wait 15 minutes for self correction.
8
Inhalt Seite
1. Einführung . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
3. Programmierung . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
4. Zutrittsoptionen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
10. Fehlersuche . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
1. Einführung
Vielen Dank dafür, dass Sie sich für den Kauf der Cat Mate Elite Selective
Katzenklappe entschieden haben.
DIESE ANWEISUNGEN SORGFÄLTIG LESEN UND DIE KATZENKLAPPE VOR
DEM EINBAUEN PROGRAMMIEREN/TESTEN.
Mit der Cat Mate Elite Selective Katzenklappe können Sie den Ein- und Austritt von
bis zu 16 Katzen kontrollieren.
Damit die von Ihnen gewählten Einstellungen nicht von Unbefugten leicht verstellt
werden können, sind die Einstelltasten so konstruiert, dass sie fest gedrückt werden
müssen.
9