Plusmed pM-T01K Mode D'emploi page 7

How to use the pM-T01K Infrared Ear Thermometer
1. To achieve accurate readings, make sure the ear canal is clean.
2. Press the "On/Off/Memory" button. The thermometer is ready for use after the
ear icon is flashing and two beeps are sounded.
3. Gently pull the ear back to straighten the ear canal and snugly position the probe
into the ear canal, aiming towards the membrane of the eardrum to obtain an
accurate reading.
4. Measuring the ear temperature: Use the index finger to trigger. Press "Start" but-
ton, a long beep will be sounded when measurement is done.
5. Power Off: Device will automatically shut off if left idle for more than 1 minute to
extend buttery life. Or press
turn the device off.
6. Fever alarm: the measuring temperature is higher than 37.5°C(99.5°F), the display
will flashing and 4 short beeps will be sounded. The measuring temperature is hi-
gher than 42.2°C(108.0°F), the display will show "Hi"and 4 short beep will be
sounded.
a. It is recommended that you measure 3 times with the same ear. If the 3 me-
asurements are different, select the highest temperature.
b. To avoid the risk of cross contamination, please clean the probe according to
"Clean and Storage" section after each use.
Scanning Mode
If you continuously obtain different measurement results, it is recommended that you
use Scanning Mode to measure. Measuring the ear temperature: Use the index finger
to trigger, press and hold the "Start" button for 3 seconds to take measurement. Du-
ring the measuring process, gently pivoting the probe side-to-side to view the entire
ear canal or in order to find the highest temperature. Release the "Start" button when
hearing a long beep sound and the measurement is completed.
Enabling or disabling the beep sound
1. Turn off the device.
2. Hold down the "Start" button, then press and hold the"ON/OFF/Memory" button
until the LCD shows °C.
3. Press the "ON/OFF/Memory" change beep sound from on to off, then release the
"ON/OFF/Memory" button.
4. After 6 seconds without changing, the beep On/Off setting will be completed, and
the unit will be entered into the measurement mode.
All manuals and user guides at all-guides.com
"On/Off/Memory" button for at least 3 seconds to
7