Switching Between Fahrenheit And Celsius; Memory Function; Cleaning And Storage - Plusmed pM-T01K Mode D'emploi

Switching between Fahrenheit and Celsius

To change the Unit from °C to °F:
1. Turn off the device.
2. Hold down the "Start" button, then press and hold the"ON/OFF/Me-
mory" button until the LCD shows °C.
3. Press the "Start" to change the °C to °F, then release the "Start" button.
4. During the setting adjustment, each old or new temperature scale set-
ting will be flashing for 6 seconds.

Memory function

There are total 9 set memories for body measurement. If the reading of the thermo-
meters is within the normal temperature range of 34 °C to 42.2 °C (93.2 °F to 108°F ),
when the measurement is done, the measurement data is saved into memory.
• Press "On/Off/Memory" button again to see the temperature stored.

Cleaning and storage

The probe is the most delicate part of the thermometer. Use with care
when cleaning the lens to avoid damage.
1. Please use the cotton swab with the Alcohol to clean the lens (on the
inside of the probe).
2. Allow the probe to fully dry for at least 5 minutes.
a. Please check the device if it falls and damages. If you can't make sure of
it, please send the complete device to the nearest retailer for recalibration.
b. Keep the unit dry and away from any liquid and direct sunlight. The probe
should not be submerging into liquids.
Change the battery
1. This thermometer is supplied with one lithium cell (CR2032).
2. Turn off the thermometer before replace the battery.
3. Open the battery cover: Hold the device and flip the battery out with a small screwdriver.
4. Insert the new battery and press the right side of the battery down until you hear a click.
5. Place back the battery cover.
* The positive (+) side up and the negative (-) side pointed down.
14
All manuals and user guides at all-guides.com