Mesto Maxima 3238 Mode D'emploi page 13

GB IRL
10 Trouble Shooting
Fault Cause
Pressure will Pump or
not build up in screw cap
the tank. not on tight
enough.
O-ring on
pump or
screw cap
faulty or not
greased.
Piston washer
faulty.
Liquid Valve disc
escapes contaminated
through the or faulty.
Pump.
Pressure Filter and/
present, but or nozzle
nozzle will not blocked.
spray.
The nozzle Nozzle insert
produces a missing.
jet, not an
atomizing
cone.
Discharge O-rings on
valve will not pressure pin
close. not greased /
lubricated.
The liquid es-
Pressure
capes before
pin (O-ring)
the lever is
faulty.
squeezed.
Use original parts only!
Some contained in spare parts pouch (1a).
Further information is available at:
www.mesto.de
0815
All manuals and user guides at all-guides.com
AUS
Solution
Tighten pump
or screw cap.
Replace or
grease O-
ring.
Replace
piston washer
(Fig.19 – 21,
25).
Clean or
replace valve
disc
(Figure 26).
Clean filter
and/or nozzle
(Fig. 23+24)
Place nozzle
insert into the
nozzle.
Grease
O-rings on
pressure pin
with lubricant
(Figure 27).
Replace
pressure pin.
Original operating instructions
USA NZ
11 Warranty
This product is covered by warranty in
accordance with the warranty regulations
applicable in your country. Wearing parts
such as seals, O-rings, piston washers etc.
and defects resulting from improper use are
excluded from the warranty.
If a defect occurs during the warranty period,
please contact us immediately (www.mesto.
de).
We will require your invoice or receipt as
proof of purchase.
12 DECLARATION OF CONFORMITY
according to EC Machinery Directive
2006/42/EC, Appendix II, No. 1A.
We,
MESTO Spritzenfabrik
Ernst Stockburger GmbH
Ludwigsburger Straße 71
D-71691 Freiberg,
declare under our sole responsibility that the
products pressure spraying devices of the
series 3238 from factory number 1201 in the
version supplied comply with all relevant pro-
visions of the Directive 2006/42/EC. Further-
more, the device complies with the Directive
97/23/EC for pressure equipment.
Rolf Rehkugler, Ludwigsburger Str. 71,
D-71691 Freiberg, is authorized to compile
the technical documentation.
Freiberg, 15.12.2011
Bernd Stockburger
- Managing Director –
13
CDN IND
6893000