Display With The Central Power Unit On; Display Of The Self-Cleaning Cycle - AERTECNICA Tubo CMT800 Manuel D'utilisation Et D'installation

CONfIGURATION IN TRBUS MODE
To set the Dynamic Control Display to TR BUS mode,
power the device and press the PROG/RESET key for 10
seconds.
The SERVICE menu will appear.
MODELLO
CONTRASTO LCD
INFORMAZIONI
REGISTRI
RESET MOTORE
X
RESET
Select MODELLO
Press MENÙ/ENTER to confirm.
The SELEZ MODELLO menu will appear
SELEZ. MODELLO
MODBUS
TR BUS
LM
LM MASTER
X
RESET
Select TR BUS
Press MENÙ/ENTER to confirm.
The Dynamic is now configured in TR BUS mode.
To exit the SERVICE menu, press the PROG/RESET key; the
following STAND BY screen will appear on the display.
The message ANOMALIA NO RETE will appear on the
display check the electrical connection.
ANOMALIA
NO RETE
V
ENTER
V
ENTER
DISPLAY wITH A
CENTRAL POwER UNIT LOCK
If the central power unit locks during operation, the
following screen will appear on the Dynamic Control
Display:
BLOCCO
CENTRALE
To identify the type of lock, consult the display on the
Master vacuum model, where the type of lock will be
displayed.
DISPLAY Of THE
SELf-CLEANING CYCLE
The following screen appears on the Dynamic Control
Display during a filter self-cleaning cycle for the central
control unit:
AUTOPUL
IN CORSO
DISPLAY WITH THE
CENTRAL POWER UNIT IN STANDBY
The display goes into STAND BY mode only when the
central power unit is off. After 30 seconds of not being
used it goes into energy saving mode, turning off the
lights.
14 TRBUS mode