Display With The Central Power Unit On - AERTECNICA Tubo CMT800 Manuel D'utilisation Et D'installation

DISPLAY wITH THE
CENTRAL POwER UNIT ON
DISPLAY
The following messages appear on the display:
A - CONTAINER fILLING LEVEL
This calculates the presumed filling level of the dust
container, using 5 progressive stages.
B - F SATURATION
ilter cartridge
This displays the saturation level of the filter cartridge
based on hours of operation.
C - CENTRAL POwER UNIT ON
This signals that the centralised vacuum system is
operating.
D - CENTRAL POwER UNIT HOURS Of OPERATION
This displays the total hours of central power unit
operation.
11
B
A
D
LM mode
C
E H
F
KEYBOARD
The keys on the Dynamic Control Display are not
enabled while the central power unit is operating.
The keys are always enabled in STAND BY conditions.
E - MENù/ENTER
This is used to display the individual menu items or to
confirm the set selection.
f - PROG/RESET
This is used to access the programming function or to
reset any lock shown on the display.
H - /
The up and down arrows are used to navigate the menu.