Display With The Central Power Unit On - AERTECNICA Tubo CMT800 Manuel D'utilisation Et D'installation

DISPLAY wITH THE
CENTRAL POwER UNIT ON
D
DISPLAY
The following messages appear on the display:
A - CONTAINER fILLING LEVEL
The presumed filling level of the dust container is
displayed with 5 progressive stages.
B - F SATURATION
ilter cartridge
This displays the saturation level of the filter cartridge
For the Perfetto TXA,TPA and TP central power units, it is
based on the actual status of the filter cartridge.
For the Classic TC central power units, it is based on
hours of operation.
C - CENTRAL POwER UNIT ON
This signals that the centralised vacuum system is
operating.
D - OPERATING VACUUM RANGE
This displays the vacuum level at which the system is
operating:
LO - OK - HI
B
A
E
C
F
G
E - OPERATING VACUUM
This displays the operating vacuum in mbar when the
system is operating.
KEYBOARD
The keys on the Dynamic Control Display are not
enabled while the central power unit is operating.
The keys are always enabled in STAND BY conditions.
f - MENù/ENTER
This is used to display the individual menu items or to
confirm the set selection.
G - PROG/RESET
This is used to access the programming function or to
reset any lock shown on the display.
H - /
The up and down arrows are used to navigate the menu.
4
H
MODBUS mode