Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DISPLAY wITH A
CENTRAL POwER UNIT ANOMALY
The following anomalies can occur during central power
unit operation:
ANOMALY DUE TO fULL CONTAINER
The following appears on the display:
The presumed container level is full.
Perform the maintenance.
After performing the maintenance with the central
power unit in STAND BY, press the MENÙ key, selecting
the container symbol and press the RESET key for a few
seconds.
This will reset the anomaly and reset normal operations.
ANOMALY DUE TO Filter cartridge SATURATION
The following appears on the display:
The presumed saturation level of the filter cartridge
was reached.
Perform the maintenance.
After performing the maintenance with the central
power unit in STAND BY, press the MENÙ key, selecting
the filter container symbol and press the RESET key for
a few seconds.
This will reset the anomaly and reset normal operations.
DISPLAY wITH THE
CENTRAL POwER UNIT IN STANDBY
The display goes into STAND BY mode only when the
central power unit is off. After 30 seconds of not being
used it goes into energy saving mode, turning off the
lights.
CENTRAL POwER UNIT STATUS DISPLAY
By pressing the MENÙ/ENTER key 1 time:
the container filling level, the saturation degree of the
h
filter cartridge and the total hours of central power unit
operation will appear together on the display.
By pressing the MENÙ/ENTER key 2 times:
the dust container symbol will appear with an
indication of the hours that have passed since the last
maintenance.
h
When maintenance is performed on the dust container,
press RESET after the operation to reset the counter.
By pressing the MENÙ/ENTER key 3 times:
the presumed saturation degree of the filter cartridge
appears with an indication of the hours that have
passed since the last maintenance.
When maintenance is performed on the filter cartridge,
press RESET after the operation to reset the counter.
OFF
h
h
h
12
LM mode
Publicité
Chapitres
Table des Matières
