Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
F E AT U R E S - O P E R AT I O N S
23. CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the
utility.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
HOW YOUR DEHUMIDIFIER WORKS
Your Bionaire
dehumidifier draws moisture laden air
®
through the intake grills on the appliance. Humid air
passes through refrigerated coils where the moisture is
removed and collected in the water reservoir.
For optimum performance, it is not recommended to use
this appliance in environments where the temperature
exceeds 37 °C or is lower than 5 °C.
The unit should only be used indoors in such areas as a
living room or bedroom. Never use it outdoors. Make
sure doors and windows are closed before using the
appliance.
PRE-OPERATING INSTRUCTIONS
1. Select a location for your dehumidifier, on a flat/
level surface, about 4 inches (10cm) away from the
wall.
2. Place unit on a stable and flat floor surface. If the
floor surface is not even, there is a risk the unit
might be unstable or topple over. Also, it may result
in excessive vibration and noise.
3. Plug the power cord into a 120V AC electrical outlet.
OPERATING INSTRUCTIONS
Operation Of Key Pads
1. When plug into power socket, 3 beep signals can be
heard. Simultaneously all indicator lights will
illuminate and the indicator lights will turn off after 1
second.
Figure 1
Dry air outlet
Permanent
drainage tube
Water reservoir
Figure 2
CONTROL PANEL
D
C
A. POWER (
): Switch
on/off.
B. SPEED (
): Setting
speed High / Low.
C. TIMER (
): Set Auto
Shut-off Timer setting
(1-8 hours)
2. Press the "POWER" (
The "Power On" indicator light will illuminate.
a. The unit is default at automatic low speed when
switched on.
b. Press the "POWER" (
will stop working.
3. Press "SPEED" (
) button to select the fan blower
working at "High speed" level or "Low speed" level.
The fan blower will automatically switch to operate at
Control panel
Handle
Humid air inlet
Filter
Water Level Window
A
B
D. HUMIDITY (
): Set
Desired Humidity
Setting (40%RH,
60%RH, 80%RH and
Stay On)
) button to turn on the unit.
) button again, the unit
Publicité
Table des Matières
