Fhiaba 599 Serie Notice D'installation page 38

Series: All
If at the rst start - up the message Stand by
does not appear, but other messages appear,
such as Fridge too warm, Fresco too warm,
Freezer too warm, or sound signals are activat-
ed, it means, it means that the appliance has
already started the cooling process.
If this is the case, deactivate any possible acous-
tic signals by pressing the Alarm button, close
the door and wait until the set temperature is
reached.
It is necessary to let the unit reach the correct
temperature before foods are stored inside.
36 www.fhiaba.com · info@fhiaba.com · Tel +39 (0)434 420160 · Fax +39 (0)434 420161
All manuals and user guides at all-guides.com
To start the appliance, connect the plug to the electrical mains: at
this point, when opening the door, the control panel will usually visual-
ize the message "Stand by", and all the panel keys be off
To turn on all the appliance compartments, press the Unit
for three seconds. The display will show the message "Initial test" for
approx. 2 minutes. After this phase the compressors will start up and re-
main on until the default temperature set up in the factory is reached.
Do bear in mind that this condition could last several hours.
If the appliance is provided with an Ice Maker, prior to switch it on
make sure that the water lter cartridge is installed, then ll the water
system. To this purpose switch off the Ice Maker.
Touch the Enter
the lling which may last a few minutes.
At the end switch the Ice Maker on again by touching the
For further information about the appliance operation, refer to the
User Manual.
and Ice Maker buttons at the same time, to start
button
button.