Battery Installation - Tineco A10 Serie Mode D'emploi

Battery Installation

Press the battery release button, and
remove the battery.
Wall-mounted Dock Installation
1. Install the accessory bracket to the rail of the wall-mounted dock and push the clip into the slot to
complete the assembly.
2. Stuck the power cord onto the slot behind the wall-mounted dock. Start from the plug end and
reserve about 5.9" (15cm) power cord to ensure that the plug can reach the charging outlet.
3. Install the wall-mounted dock to the wall with the nails provided by Tineco.
Determine the best wall location for mounting the
dock. We recommend placing it 43.3" (110cm) from
the lower screw hole to the floor (may need to be
adjusted based on the actual situation).
Warning:
• Ensure the wall surrounding the mounting area is free of gas, water pipes, electrical cables and wires.
• To avoid the dock falling, ensure it is firmly installed.
To replace, slide the battery into the slot at
the base of the main body. The battery will
click into position when correctly fitted.
43.3"
(110cm)
28
5.9"
(15cm)