Mendip Stoves ASHCOTT WIDE Guide D'utilisation Et Mode D'emploi page 8

STOVE PERFORMANCE & TESTING
Ashco� Wide is tested in accordance with EN 13240. It is recommended as suitable for use in smoke
control areas when burning wood logs and when fi�ed with a mechanical stop to prevent closure of the
secondary air control beyond :
Output
Wood
Ashco� wide 4.7kW
Ashco� Wide
Output
Range kW
Ashco�
4-6
Wide
Chimney Connec�on
In order for the stove to perform sa�sfactorily the chimney height must be sufficient to ensure an
adequate draught to clear the products of combus�on and prevent smoke problems into the room.
Tested Gas flow rates flue
gas temperatures
Ashco� Wide
NOTE: A chimney height of not less than 4.5 metres measured ver�cally from the outlet of the stove to
the top of the chimney should be sa�sfactory. Alternately the calcula�on procedure given in BS 5854:1980
may be used as the basis for deciding whether a par�cular chimney design will provide sufficient draught.
DISTANCE to COMBUSTIBLE MATERIALS
Combus�ble materials should not be located where the heat dissipa�ng through the walls of fireplaces or
flues could ignite it. Therefore when installing the stove in the presence of combus�ble materials due
account must be taken of the guidance on the separa�on of combus�ble material given in Building
Regula�ons Approved Document J and also in these stove instruc�ons. The minimum distances to
flammable materials are specified on the EN 13240 plate on the back of the stove.
Distance to combus�bles rear /
rear with addi�onal heat shield
300mm /50mm
Efficiency Recommended for
wood smoke control
75.0% YES
Log Length
SE dimensions
Length
LxWxD cm
35cm 25x14x11
Par�culate ma�er
CO@13%
@13% mg/nm3
0.04(W)
Flue gas flow rate
Wood /coal
5.7 g/sec
Distance to combus�bles sides
Mechanical air stop
for SE Model
YES
Logs
1
Nox @13%
31 151
Test Flue gas Temperature
wood /coal
253 Deg C
300mm
8 of 40
Mechanical stop secondary.
(Measured from le� leg)
345mm
Wood Reload Weight wood
1hr 1.2kg
CxHy@13%
Compliant
54
Pascals Pressure
12pa
Suitable for 12mm hearth
YES
load
2022
YES