Mendip Stoves ASHCOTT WIDE Guide D'utilisation Et Mode D'emploi page 5

Insta lling t h e A s h co tt W i d e stove
Adjustable legs
The Ashco� Wide wood burning stove is
fi�ed with adjustable legs allowing the
stove to be installed on an uneven floor.
To adjust the legs, prior to installa�on,
wind down M8 bolts using a 13mm
spanner so they protrude just below the
the stove legs. Tighten the locking nut
once the desired level is reached. Do this
with the stove �lted up from the leg
being adjusted. Place the stove in
posi�on and level the stove. If the stove
is to be placed on a glass floor plate it is
necessary to use rubber feet so as not to
scratch the glass plate. (This may cause the plate to sha�er).
Exchanging collar posi�on from top to rear
The Ashco� is supplied with the top collar already installed, to exchange the collar from the top posi�on
to the rear take the following steps:
1) Using a 4mm Allen key to remove the flue collar by unbol�ng from
the body of the stove.
2) Break off tabs on rear convec�on panel and remove the laser cut
sec�on. To do this the rear convec�on panel does not need to be
removed.
3) Remove rear cover plate from the rear flue posi�on. Place this plate
on the top exit flue posi�on and secure down �ghtly using the bolts
from the rear posi�ons. The top cover plate will have a a flat rope
seal already fi�ed.
4) Fix the cast iron collar onto the rear outlet using the bolts that
secured the collar originally.
5) Replace top plate.
6) Take the convec�on top cover plate, supplied with the stove, and
place this in the hole in the top plate.
Securing collar to flue pipe
A physical reten�on of the flue pipe is required for both top and rear exit flue configura�ons.
1) Fit the flue pipe into the flue collar. Sealing with a suitable fire cement.
2) For a top flue outlet. Li� up and support the top plate allowing enough room to drill a hole
through the flue collar and into the flue pipe.
3) Secure the collar and flue pipe with a suitably sized self tapping screw.
5 of 40