Mendip Stoves ASHCOTT WIDE Guide D'utilisation Et Mode D'emploi page 15

The refuelling procedure : -
Allow the newly charged fuel to burn with the secondary air control set at maximum for up 3 to 4
minutes. A�er this period, with flames from the logs fully established, close the secondary air supply to
the low output se�ng. When opera�ng at high output (secondary air set fully open) the new refuel charge
does not require any boost air to establish combus�on.
Refuelling on to a low fire bed
If there is insufficient burning material in the firebed to light a new fuel charge, excessive smoke emission
can occur. Refuelling must be carried out onto a sufficient quan�ty of glowing embers and ash that the
new fuel charge will ignite in a reasonable period. If there are too few embers in the fire bed, add suitable
kindling to prevent excessive smoke.
Fuel Overloading
The maximum amount of fuel specified in this manual should not be exceeded, overloading can cause
excess smoke.
Air controls & doors le� open
Opera�on with the air controls fully open can cause excess smoke. The appliance must not be operated
with air controls, or door le� open except as directed in the instruc�ons.
SE- smoke exemp�on modifica�on
View of the rear of the stove.
15 of 40
To fit the air stop, screw in
3mm grub screw ensuring
that control lever travel is
limited.
Fig 3