Lexmark OptraImage 443 Guide Rapide page 25

Step 11: Verify the setup
Make a test copy
Send a test fax
If Send/Fax is disabled, this option does
NOT appear.
OptraImage Setup Guide
Test scan
to network
Copy mode is the default setting of the control panel.
1
Make sure the Ready status message is displayed.
2
Place your original in the scan unit.
3
Press Go/Send to send a copy to your printer.
Send a one page test fax to someone and ask for feedback.
1
Press Fax/Scan Mode once. Enter Phone # displays on
the OptraImage control panel.
2
Use the numeric keypad on the control panel and enter
the phone number of the person receiving the fax.
3
Place your original in the scan unit.
4
Press Go/Send to send a fax.
Test your scan to network functions by creating Scan Profiles
or scanning to permanent destinations.
Remember you can only test the scan to network functions
that you configured during setup. For example, to test Scan
to e-mail, you must have created at least one permanent
e-mail destination. Otherwise, SCAN → EMAIL does not
appear as a scan to network mode in the OptraImage control
panel.
23