Racing RAC1050ET-1 Instructions Originales page 31

Troubleshooting
Problem
Motor does No electricity
not start
Defective cable
Defective safety
switch/plug
combination
Overheat protection
actived
Abnormal Blade is jammed
noises
Lubrication running
out
Loose bolts, nuts or
other securing
components
Abnormal Blades damaged or
vibrations worn
Working depth too
large
Poor Working depth too
scarification small
results
Worn blades
Possible causes
Check mains connection
Check cable, plug in, replace if required,
or have it repaired by a qualified person
Arrange for repair in a specialist workshop
1. Working depth too large, set to the
shorter depth
2. Blades blocked, remover the blockage
3. Soil too hard, select correct work depth
and forwards and backwards several times
while slowly down the operation speed.
wait till the motor cool down for around 15
minutes before rework
Switch off wait till complete stop. Remove
the objects
Arrange for repair in a specialist workshop
Tighten all components, contact specialist
workshop if noises prevail
Replace or have it checked by an
specialist workshop
Set to correct working depth
Set to correct working depth
Replace or have it checked by an
specialist workshop
30
Remedy