Racing RAC1050ET-1 Instructions Originales page 29

Caution! Disconnect the mains and wear protective gloves.
To remove the complete tines from the shaft:
Remove the lock pin from the end of the shaft.
Take off the outer tine set from shaft.
Remove the lock pin and take off the inner tine set from tine shaft.
Reverse above steps to install tines.
Change tines from bracket
When one or two pieces of tine broken, it is necessary to change the damaged tine
instead of complete tine set.
Loosen the screws from one side while hold the lock nuts from other side.
Take off the damaged tine and replace with the new one.
Checking lubricant (Fig. 6)
Empty and refill the lubricant after first 1 hour operation, and every 40 hours for
heavy duty operation.
Replace grease with type Multifak EP-0.
Drain screw plug (17) is located on the right side of transmission housing.
Lay the tiller on its left side and clean the transmission to prevent dirt and debris
before remove the drain screw.
Using a hex key 5mm to unscrew the plug and empty the oil from the
transmission housing.
Fill up by using a grease gun with a high-quality, automotive-grade grease until it
begins to seep out around the edge of the hole of the nozzle.
If necessary, disassemble tines.
Reinstall the drain screw plug.
Storage
The application should be stored in a dry and clean room and out of reach of
children.
During extended periods of storage, during the winter for example, ensure that the
application is protected against corrosion and frost.
At the end of the season, or if the application is not to be used for longer than a
month:
Clean the application.
Wipe over all metal surfaces with an oil-impregnated cloth to protect them from
28