Racing RAC1050ET-1 Instructions Originales page 24

Be aware of extension cord while operation. Be careful not to trip over cord.
Always guide the cord away from tines at all times.
If the device strikes a foreign body, examine the application for signs of damage
and carry out any necessary repairs before restarting and continuing to work.
If the device should start to vibrate abnormally, switch off the motor and check for
the cause immediately. Vibration is generally a warning of trouble.
Holding the guide bar and lift the application to move it from one place to another.
Always switch off the device, disconnect the plug and wait until the application
stops before carrying out maintenance or cleaning work. Caution! Tines do not
stop immediately after switching off.
Use caution when cleaning or performing maintenance on the device. DANGER!
Watch your fingers! Wear gloves!
It is forbidden to move or modify any of the electrical and mechanical safety
devices.
The machine must be stopped when carrying out maintenance and cleaning
operations, when changing tools or when transported by means other than under
its own power. If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service agent.
Electrical safety
The mains voltage must correspond to the one marked on the technical data plate
(230V~50Hz). Do not use other sources of power.
The use of a safety circuit-breaker is recommended for the power supply line for
an intervention range of 10 to 30 rated mA. Consult a reliable electrician.
Never pass the device over the extension cable that the application is working, as
this could cut the cable. Mark sure you always know where the cable is.
Use the special cable holder for the connection of the extension cable.
Never use the device when it is raining. Try to prevent it from getting wet or being
exposed to humidity. Do not leave it outside overnight. Do not cut damp or wet
grass.
The power supply cable should be checked regularly and before using it each
time, make sure the cable is not damaged or old out. If the cable is not in good
condition, do not use the device; take it to an authorized service center instead.
Only use an extension cable that is suitable for outdoor work. Keep it away from
the cutting area, from damp, wet or oily surfaces or with sharp edges and away
from heat and fuels.
The mobile socket of the extension cable should be splash proof in compliance
23