Racing RAC1050ET-1 Instructions Originales page 25

with DIN 57282 and VDE 0282 regulations; the cross-section of the wire (max.
length 75 m) should be at least 1.5 mm
Before starting up
Intend use
This appliance is only intended as an electric tiller for aerating lawns and
grassy areas in private domestic and hobby gardens.
It is not designed for use in public areas, parks, sports areas, and in agriculture and
forestry.
Using the application for any other purpose is considered incorrect and unapproved.
The manufacturer is not liable for any damage or injury resulting from such use. The
user is entirely responsible for any associated risks.
Double insulation
The application has double insulation. This means that all external metal parts are
insulated from the electrical supply.
This is achieved by introducing an insulation layer between electrical and
mechanical parts. The double insulation guarantees you the greatest possible
safety.
Overload protection
If the application is blocked by a foreign object or if the motor is overloaded, the
motor will switch off automatically by the protection device. Release the trigger level
and wait till the motor cool down (approx. 15 minutes) then start application again.
Electric/Mechanical break system
This application is equipped either with electric break system or mechanical system
to ensure the rotating tines stops within 2 seconds after releasing of safety switch.
Assemble (Fig. 1)
Guide bar
Slide the upper guide bar (25) into bracket (26) till the positition that holes on
bracket align with the one on guide bar.
Tighten the bracket after setting at the appropriate position by 2 supplied screws
using a screwdriver.
Attach the handle bar (25) to the guide bar middle section (29) and fix by two
. Use H07RN-F harmonized cable.
2
24