Racing RAC1050ET-1 Instructions Originales page 26

supplied screws (27) and swing nuts (30).
Mount guide bar (29) to lower section (32) and fix by two supplied screws (27)
and swing nuts (30).
Tighten all screws and nuts completely.
Using supplied two cable clips (28) to hold cable.
Additional wheels
Install the wheels (35) to the bar lower section (32) and fix by supplied screw (33)
and swing nut (45).
The setting of the height determines the working depth. The longer the setting, the
deeper the unit will work in the earth.
Turn up side the wheels during working position reach the maximum working depth
(Fig. 4).
Starting
Connection the mains (Fig. 2)
Secure extension line with cable relief (26) and connect the mains plug of the
appliance.
The loop of the mains wire must be long enough for the cable relief to be able to
slide from one side to the other.
Starting up (Fig. 3)
Warning! The tines starts rotation immediately after switch on! Keep hands and feet
away from cutting tines.
To switch ON, hold the appliance firmly with two hands and press the Safety lock
off button (A) while press the On/Off switch trigger (B).
Keep the switch trigger hold while release the button.
To stop the appliance, release the trigger level and it automatically returns to its
start position.
Use the tiller for breaking sod, preparing seedbeds, and for cultivating gardens and
flower beds. The tiller can also dig small holes for planting saplings or potted plants.
Tips
Move the application to the work area prior to starting the motor.
Hold the application firmly while switch on.
The tines will pull the tiller forward during operation, press the guide bar to lower
the tines slowly.
25