Cleaning And Maintenance - Bosch HEZTR301 Manuel

Inserting Telescopic Rack into Oven
CAUTION
9
To avoid burns, place oven racks in desired
positions before turning oven on. Always use oven
mitts when the oven is warm. If a rack must be
moved while the oven is hot, do not let oven mitts
contact hot heating elements.
To avoid possible injury or damage to the
appliance, ensure rack is installed exactly per
installation instructions and not backwards or
upside down.
Slide the rack in evenly until the rear of the rack is
1.
about 2 inches from the back of the oven.
Tilt the front of the rack up about three-quarters of an
2.
inch (A) and finish pushing the rack all the way back
(B).
NOTICE: Avoid striking the oven light cover glass or
the back of the oven when pushing the rack into
position.
The back of the telescopic rack drops into place.
3.
Pull the rack forward to engage the bottom of the rack
4.
onto the rear of the rack position guide.
Lower the front of the rack to finish seating it on the
5.
rack guide. The rack should feel stable when properly
seated.
Slide the movable part of the telescopic rack in and
6.
out a few times to make sure it is able to move freely
and that the non-moving part of the telescopic rack is
securely anchored.
To remove the telescopic rack from the oven
Lift the front of the telescopic rack assembly about
1.
1/2 inch and push the rack to the rear about 3/4 inch.
This allows the rack to disengage from the rack
position guide.
Lift the rear of the telescopic rack assembly so it
2.
clears the rack position guide and gently pull the rack
from the oven.
Note: Take care to avoid pulling the rack unevenly
which will cause it to bind during removal, catching on
the oven walls.
CAUTION
9
To avoid possible injury or damage to the
appliance, ensure the telescopic rack is installed
exactly per installation instructions and not
backwards or upside down.

Cleaning and Maintenance

CAUTION
9
Allow the rack to cool before cleaning or placing
▯
in water.
Do not use abrasives or corrosive cleaning
▯
agents.
Wash rails of the telescopic racks with soapy water.
Rinse thoroughly and dry, or gently rub with cleansing
powder or soap-filled pads as directed. Avoid getting
cleansing powder in the telescopic slides.
NOTICE: DO NOT leave the rack in the oven during self
clean. If the telescopic rack is cleaned in the oven during
the self clean mode it will loose its shiny finish and will
not glide smoothly.
Re-lubrication of the rails may become necessary, if the
rack is exposed to a self-clean cycle. Use only high
temperature food-grade lubricants to re-lubricate slides
(call customer service for more information).
See image below for lubrication points (A).
3