Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OFA Kam 6 Hybrid Owners Manual Fr-Eng.fm Page 20 Monday, April 11, 2005 12:45 PM
OFA Kameleon™ 6-Device Hybrid Remote
PROBLEM:
No display when programming.
SOLUTION:
Display has turned off due to
inactivity. Start programming
again and do not pause while
performing instructions.
PROBLEM:
During programming, the two
inner IR segments display a
long flash.
SOLUTION:
An invalid entry has occurred.
Check the keys to be pressed
and start programming again.
PROBLEM:
IR sent animation is displayed
when you press a key, but
home entertainment device
does not respond.
SOLUTION:
Make sure the remote control
is aimed at your home
entertainment device and is
not farther than15 feet away.
PROBLEM:
The unit does not control
home entertainment devices
or commands are not working
properly.
SOLUTION:
Try all listed codes for the
device brands being set up.
Make sure they can be
operated with an infrared
remote control.
PROBLEM:
Tried Searching For Your
Code method and still could
not find a working code.
SOLUTION:
Perform Restoring Factory
Default Settings on page 17.
Then repeat Searching For
Your Code on page 10.
PROBLEM:
Cannot program a macro onto
M1, POWER or other keys.
SOLUTION:
Make sure the total number of
key presses being
programmed is less than 15
and that you are not trying to
program a macro on an
invalid key (Device keys, Set
Key and Fav key).
20 Troubleshooting
PROBLEM:
Power macro does not
execute.
SOLUTION:
Make sure to press and hold
the POWER for at least three
seconds to initiate Power
Macro.
PROBLEM:
Changing channels does not
work properly.
SOLUTION:
If original remote control
required pressing ENTER or OK
to change channels, press
ENTER or OK on the remote
control after entering the
channel number.
PROBLEM:
During learning, Inner IR
Segments display a long blink
after pressing and holding key
to be learned.
SOLUTION:
Memory is full or a bad
capture has occurred. Avoid
high-ambient light sources,
such as direct daylight and
fluorescent bulbs. Try
readjusting positions of
remote controls before
performing the procedure
again.
PROBLEM:
Tried Search For Your Code
method and still could not
find a working code.
SOLUTION:
Clear the device key as
follows:
Press and hold SET until
1.
the Inner IR Segments
blink twice, then release.
Enter 9 9 2.
2.
3.
Press the device key to be
cleared twice.
4.
Repeat the Search For
Your Code method.
Publicité
Chapitres
Table des Matières
Dépannage
