Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OFA Kam 6 Hybrid Owners Manual Fr-Eng.fm Page 12 Monday, April 11, 2005 12:45 PM
OFA Kameleon™ 6-Device Hybrid Remote
7.
Repeat step 6 up to three more times to
add the other desired devices to the
power-on sequence (e.g., AUX,
VCR/PVR, etc.).
8.
To save the settings and exit the
program, press and hold SET until the
Inner IR segments blink twice, then
release SET.
T
O
M
P
O
PERATE
ASTER
OWER
1.
After programming, point the remote
control at the devices and press
POWER for at least 3 seconds to
sequentially turn on (or off) your
devices.
NOTE: When POWER is pressed for less than
3 seconds, a power command will only be
sent to the currently-selected device. This
allows you to still individually power
devices on or off.
2.
Devices will turn on (or off) according
to your programmed sequence.
NOTE: The currently-selected device will
always turn on or off first, followed by the
remaining programmed sequence. After the
master power sequence has been
completed, the remote control will be set to
control the first powered-on device.
NOTE: If one or more devices does not have
a POWER key, the power off/on sequence
may be slightly delayed when the remote
control signals the device(s).This action is
normal.
C
A M
LEARING
ACRO
1.
Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
2.
Enter 9 9 5. The Inner IR Animation
will blink twice.
12 Using Channel Scan
3.
Select a macro key (e.g., M1, POWER or
any key programmed with a macro)
you want to clear and press it once.
4.
Press and hold SET until the two Inner
IR segments flash twice, then release
SET. The macro is now deleted but the
keys (in the case of power), will retain
their original function.
USING CHANNEL SCAN
M
ACRO
In the TV, VCR/PVR, DVD and CBL/SAT
modes, use the FAV key to start a 3-second
scan of all favorite channels (if
programmed, see Programming Favorite
Channel Scan below) and/or all channels for
the selected mode.
1.
Press TV, VCR/PVR, DVD or CBL/SAT
once.
2.
Press FAV once.
•
If Favorite Channel Scan has been
set up, scanning of favorite
channels will start and, upon
completion, continue to scan all
channels upward for the same
device.
•
If Favorite Channel Scan has not
been set up, scanning will start
with the current channel, then
proceed to the next channel up,
and continue until all channels of
the selected device is scanned.
3.
To stop scanning channels at any time,
press any key once.
PROGRAMMING FAVORITE
CHANNEL SCAN
In the TV, VCR/PVR, DVD and CBL/SAT
modes, you can store a list of up to 10
favorite channels, in any order, that will be
Publicité
Chapitres
Table des Matières
Dépannage
