Programming The Remote Control - Metz RM17 Mode D'emploi

Programming the remote control

Programming the remote control with
the device code
• switch on your external AV device.
• sselect a code from the device code list
for your AV device
• press the button
to be programmed (about 5
AUX
sec), until the upper button row briefly
flashes twice.
• enter the four digit device code for your
AV device within 10 seconds.
• enter the four digit device code for your
AV device within 10 seconds.
If all the buttons
TV
DVD
,
fare illuminated for about two
seconds, this indicates an error, or
that the entry was incomplete.
Repeat the entry.
• to test the programming switch off the
external AV device with the button
of this remote control.
If the external AV device switches off, a
matching code has been programmed.
If the external AV device does not switch
off, program the next code from the devi-
ce code list.
Check additional functions.
If several buttons for basic operation do
not work, enter the next code from the
device code list.
or or
STB
DVD
STB
AUX
, ,
Conduct manufacturer search
• switch on your external AV device.
• select a code for your AV device from
the manufacturer code list.
• press the button
to be programmed (about 5
AUX
sec), until the upper button row briefly
flashes twice.
• within 10 seconds enter the four digit
code 0 0 0 3 to activate the search.
To confirm that the search has been
activated the upper button row briefly
flashes twice
• enter the four digit manufacturer code
within 10 seconds according to the
manufacturer code list at the end of the
operating instructions.
• the button to be programmed acknow-
ledges the code entry by flashing twice.
• Hold down the button
te control until the external AV device
switches off. If the external AV device
switches off during the search, immedi-
ately release the button
the button .
The setting thus found is saved.
The button flashes twice.
If the external AV device switches off, a
matching code has been programmed.
Check additional functions.
If several buttons for basic operation do
not work, enter the next code from the
device code list.
or or
STB
DVD
of this remo-
and press
11