Deactivating The Buttons; Programming The Remote Control With The Device Code For Av Devices; Conduct Manufacturer Search - Metz RM19 Mode D'emploi

3.2 Deactivating the buttons

DVD
Deactivating the button:
DVD
F1
• Press the and
TV
three seconds. The ,
quickly three times.
Controls:
DVD
When you press the button, it does not illuminate and there-
fore no longer functions.
The same procedure also applies to the
3.3 Programming the remote control with the device code for
AV devices
• Switch on your external AV device.
• Select a code from the device code list for your AV device.
DVD STB
• Press the or or
(about five seconds), until the upper button row briefly flashes
twice.
• Enter the four-digit device code for your AV device within ten
seconds.
• The button to be programmed acknowledges the code entry of an
existing code by flashing twice.
TV
If all the buttons
for about two seconds, this indicates an error, or that the
entry was incomplete. Repeat the entry.
• To test the programming, switch off the external AV device with the
button of this remote control.
If the external AV device switches off, a matching code has been
programmed. If the external AV device does not switch off,
buttons at the same time and hold for
STB
DVD AUX
, and buttons flash
STB AUX
and
AUX
button to be programmed
DVD STB AUX
, , , are illuminated
program the next code from the device code list.
Check additional functions.
If several buttons for basic operation do not work, enter the next
code from the device code list.

3.4 Conduct manufacturer search

• Switch on your external AV device.
• Select a code for your AV device from the manufacturer code list.
DVD
• Press the
(about five seconds), until the upper button row briefly flashes
buttons.
twice.
• Within ten seconds enter the four-digit code "0003" to activate the
search.
To confirm that the search has been activated, the upper button
row briefly flashes twice.
• Enter the four-digit manufacturer code within ten seconds accor-
ding to the manufacturer code list at the end of the operating
instructions.
• The button to be programmed acknowledges the code entry by
flashing twice.
• Press and hold the
external AV device switches off. If the external AV device switches
off during the search, immediately release the
press the XXX button. The setting thus found is saved.
The button flashes twice.
If the external AV device switches off, the matching code has been
programmed.
Check additional functions.
If several buttons for basic operation do not work, enter the next
code from the device code list.
14
STB AUX
or or button to be programmed
button of this remote control until the
button and