Metz RM17 Mode D'emploi page 12

Programming the remote control
Carry out complete code search
• switch on your external AV device.
• press the button
to be programmed (about 5
AUX
sec), until the upper button row briefly
flashes twice.
• within 10 seconds enter the four digit
code 0 0 0 1 to activate the search. The
upper button row briefly flashes twice to
confirm that the search has been activa-
ted.
• Hold down the button
te control until the external AV device
switches off. If the external AV device
switches off during the search, immedi-
ately release the button
the button .
The setting thus found is saved.
The button flashes twice.
If the external AV device switches off, a
matching code has been programmed.
The complete code search can take
up to 10 minutes.
12
or or
DVD STB
of this remo-
and press
Delete programming of a button (RESET)
• hold down the button
or to be programmed (about 5
AUX
sec), until the upper button row briefly
flashes twice.
• enter the four-digit code 0 0 0 0 within
10 seconds.
• the button to be programmed acknow-
ledges the code entry by flashing twice
After a RESET the button
grammed for the Metz HD250 as default.
or
STB
DVD
DVD
sis pro-