•
Min. and max. lithium battery voltage: 10V – 14V
3.8
Warning symbols
General warning
Duty of reading the use &
maintenance manual
Compulsory head protection
4 INSTALLATION
4.1
Start-up
•
Remove the power unit (1) and the cable (14-15) from their box.
•
Assemble the power unit onto the extension pole with the chosen harvesting head. Insert the shaft (10) and tighten the
screws (2) of the clamp connection (3).
•
Insert the power supply cable (14-15) into the handgrip hole.
•
Join the power supply cable (14-15) with the connector (4) taking care of the male and female connections. Use the
antierror device for the proper connectors insertion.
•
Start the tool by means of the ON/OFF switch (7) and check the led light (9) is on.
4.2
Selection and variation of the speed
On the ON/OFF switching sticker press the button (8) to select the motor speed: position I: 1080 rpm, position II: 1140
rpm.
4.3
Procedure for setting/unsetting the power saver function
•
Connect the power unit to the battery
•
Do not start the tool, keep the speed selector (8) pressed for 5 sec., until the ON red led light (9) flashes confirming the
operation.
•
Start the tool with the power saver function inserted. The ON red led light (9) flashes.
To unset the power saver funcion, keep the speed selector (8) pressed for 5 sec,. until the ON red light (9) flashes,
•
confirming the operation.
•
Start the tool without the power saver function inserted. The ON red led light (9) does not flash.
WARNING!
•
Please find all the indications and warning about the lithium battery use in the enclosed battery instructions.
•
When starting the power unit, the harvesting head assembled on the extension pole begins moving immedi-
ately. Be very careful when positioning the tool. It shall be far from people and things. Neglecting this warning
could creating dangers for the operator.
Use and Maintenance Manual – Original
Instructions Rev.: 01, Data 12/07/2022
Compulsory adequate clothing
Compulsory hands protection
Compulsory feet protection
Pag. 25