Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
On the body there is a connector (4), which, by means of a cable, joins the power unit with the battery. The lead battery is
fitted with a 13 m cable (14) and connecting clamps (6). The lithium battery is fitted with a 1.5 m cable (15).
On the top of the handgrip body (1) there is a clamp connecting (3) for the fixed (12) or telescopic (11) extension pole,
which transmits motion to the tool.
IMPORTANT!
In case of excessive efforts, a temporary stop of the tool could occur. This would be driven by the speed control-
ler in order not to damage the unit. After having removed the tool from the branches and having switched off and
then on the speed controller by means of the ON/OFF switch (7), the tool can be started again.
WARNING!
It is strictly forbidden to start the engine of any vehicle with the power-supply cable of the tool connected to the
battery through the clamps of the cable.
WARNING!
Please mind the tool was created for the aim indicated in this manual.
3.3
Parts supplied
•
Use & maintenance manual.
3.4
Recommended use
The tool was created to be used according to the ways and limits previously described.
WARNING!
Any other use has to be considered improper and potentially dangerous for the operators' safety. This would
•
make any warranty claims void.
If it is not used for the purposes it was designed for, the tool may get damaged and cause serious injuries to
•
personnel and bystanders and damages to things.
3.5
Tool parts
Pos.
Description
1
Handgrip
2
Extension pole locking screws
Extension pole fixing clamp
3
connection
4
Shells connector
5
Plate
6
Battery clamps
7
ON/OFF switch
8
Speed selector
9
Led light
10
Extension pole shaft
11
Telescopic extension pole
12
Fixed extension pole
13
Power supply cable connector
14
13 m power supply cable
15
1.5 m power supply cable
16
Speed selector led lights
3.6
Technical details
•
Power unit weight:
•
Motor rotation speed I:
•
Motor rotation speed II:
3.7
Safety devices
•
Built-in safety device: stops the tool automatically in case of motor overheating.
•
ON/OFF Led light (9): indicates the tool is working.
•
Poles inversion protection in connection with the lead battery.
Pag. 24
Function
Contains the gearbox, the speed controller and the ON/OFF switch-
ing sticker
Allow to lock the extension pole
Locks the extension pole
Connects the power unit with the power supply cable
Shows the identification details
Connect the power supply cable with the battery poles
Starts and stops the tool
Allows to choose the motor rotation speed
Shows if the tool is on or off
Transmits motion from the power unit to the harvesting head
Holds the tool
Holds the tool
Connects the power unit with the power supply cable
Connects the power unit with the lead battery
Connects the power unit with the lithium battery
Indicate the selected speed
850 g
1080 ± 20 rpm
1140 ± 20 rpm
Use and Maintenance Manual – Original
Instructions Rev.: 01, Data 12/07/2022
PICT. NO.
A
A-C
A-C
A-C
A
E
B
B
B
C
C-D
C-D
C-E
C-E
G
B
Publicité
Chapitres
Table des Matières
