Install Flue Mounting Bracket - Best WPB9 Serie Mode D'emploi

INSTALL FLUE MOUNTING
BRACKET
1. Carefully center the mounting bracket directly
over the range hood location.
2. Secure the bracket to the wall using (2) 6 x
60mm mounting lag screws (Fig.11). Make
sure the bracket is pushed into the corner,
tight against the wall if necessary, and
centered over the hood. Complete the
installation.
3. Attach ductwork to damper/duct connector.
4. Run 8" diameter metal ductwork to the
outside location (Fig.12).
5. Install an appropriate wall or roof cap with
damper to exhaust the air to the outside.
6. Tape all duct joints with aluminum duct tape.
7. Install upper and lower decorative flues
onto the range hood (Fig.13).
8. Secure upper flue to flue mounting bracket
with (2) 3.9 x 6mm screws (Fig.14).
MOUNTING
SCREWS
(3,9x6mm)
CEILING
FIG. 14
- 12 -
MOUNTING LAG
SCREWS (6x60mm)
FIG. 11
DECORATIVE
FLUE
DUCT TAPE
8"ROUND
METAL DUCT
FIG. 12
FIG. 13