Lite Thermostat Reset; Initial Configuration Evaluation; Advanced Settings - Airzone RADIANT365 Guide D'installation Rapide

If the association is correct, the LED
red twice, it means the thermostat is out of range.
Remember: If you need to change the zone number, reset the thermostat and start association process.
ES

Lite thermostat reset

EN
If you want to return your Lite thermostat to factory values, pull down all the microswitchs and reinsert the thermostat in its
base. The LED will flash green twice when the reset process is completed.
FR
IT

INITIAL CONFIGURATION EVALUATION

Check the following aspects:
PT
- When power supplying the control module of radiant elements (AZRA6OUTPUT8Z), status LEDs (O1-O6) will light up
for 15 seconds.
DE
- Opening-closing of the dampers and control outputs: Turn on the system and generate demand in all the zones. Then,
switch off and on all the zones to verify the associated control outputs are correct.

ADVANCED SETTINGS

To access the advanced configuration menu of the thermostat and Blueface Think follow the following steps:
Blueface
Press and hold
Think
Important: Use
Press once
From this menu you can change the system and zone parameters.
32
will flash green 5 times. If it flashes red, it means the zone is already occupied. If it flashes
to confirm and to return.
Press and hold Press and hold