Black & Decker NVB115W Mode D'emploi page 7

Leave the appliance to charge for at least 21 hours.
u
While charging, the charger may become warm. This is
normal and does not indicate a problem.
The appliance can be left connected to the charger
indefinitely.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
Switching on and off (fig. E)
To switch the appliance on, press and hold the on/off
u
switch (1).
To switch the appliance off, release on/off switch (1).
u
Dry pick up (NVB units Only)
For everyday spills of dry material.
u
Warning! Never pick up wet applications with these units.
Wet and dry pick up (WDB units Only)
For everyday spills of dry material, use your appliance
u
without the squeegee accessory.
Warning! Your product is designed for light spills only.
This appliance can also be used to pick up everyday liquid
u
spills. Use the squeegee accessory on non-absorbent,
hard surfaces. On absorbent surfaces, such as carpet,
your appliance will pick up wet spills better without the
accessory.
For best performance on hard surface wet pickups, insert
u
squeegee into the bowl nozzle opening.
For best results when using this accessory, hold the
u
appliance at an angle of 45° and pull it slowly towards
you.
Do not fill the bowl beyond the end of the intake chute. If
u
there is any liquid in the bowl, do not turn the unit upside
down, sideways, point the nozzle upward, or shake the
vac excessively.
After picking up liquid substances clean the appliance and
u
filter immediately. Mold and mildew may form if the unit is
not properly cleaned after wet pickups.
Before charging, be sure to empty all liquid contents and
u
dry thoroughly, to avoid damage to your appliance.
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filters (fig. F & G).
Warning! The filters are re-usable and should be cleaned
regularly.
Press the bowl release button (2) and pull the dust bowl
u
(3) straight off.
(Original instructions)
While holding the dust bowl over a bin or sink, pull out the
u
filter to empty the contents of the bowl.
To replace the dust bowl, place it back onto the handle
u
until it "clicks" firmly into position.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
Foam insert (fig. H) (WDB units Only)
Place the foam insert (8) into the centre of the wet/dry
u
deflector (9).
Warning! Never use the appliance for wet applications without
the water deflector and foam insert fitted.
Pre-filter (fig. I) (NVB units Only)
The Filter and pre-filter can be separated to allow better
cleaning.
Twist the pre-filter (7) in an anti-clockwise direction and lift
u
from the filter (6).
Warning! Never pick up wet applications with these units.
Cleaning the dust bowls and filters
The dust bowls and filters can be washed in warm soapy
u
water.
Make sure that the filters and the dust bowl are dry before
u
re-fitting.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your Black & Decker
dealer:
For models: NVB115W, NVB115WA, NVB215W, NVB215WA
use filter part number FLVD10-XJ
For models: WDB115W, WDB115WA, WDB215W,
WDB215WA use filter part number FLVWD10-XJ
Maintenance
Your Black & Decker corded/cordless appliance/tool has been
designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
ENGLISH
7