Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEp 12: (SEE fIGUrE 12)
1.
Attach the latch stand and the wheel support braces
to the poly tray using four 1/4" x 1" hex bolts (D),
5/16" washers (W), and 1/4" nylock nuts (I).
D
W
I
fIGUrE 12
STEp 13: (SEE fIGUrE 13)
1.
Raise the tongue to the latch stand and engage the
latch to ensure proper alignment. Adjust as needed.
2. Tighten all fasteners.
fIGUrE 13
STEp 14: (SEE fIGUrE 14)
1.
With the valve stem facing out, place the wheel onto
the axle and secure with a 1" washer (M) and a 3/16"
x 2" cotter pin (T). Spread the ends of the cotter pin.
Repeat for the other side.
T
fIGUrE 14
7
VALVE STEM
M
T
Publicité
Table des Matières
