Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEp 4: (SEE fIGUrE 4)
1.
Attach the pedal bracket (7) and the latch (10) to the
tongue using two 3/8" x 3-1/4" clevis pins (V), four
spacers (J), two 3/8" x .875" washers (L), and two
3/32" x 1/8" hair pins (S).
J
V
7
fIGUrE 4
STEp 5: (SEE fIGUrE 5)
1.
Attach the extension spring (12) to the hole in the
tongue and the hole in the latch.
fIGUrE 5
10
L
S
12
STEp 6: (SEE fIGUrE 6)
1.
Attach the axle (9) to the wheel support using a
5/16" x 1-3/4" hex bolt (B) and a 5/16" nylock nut
(H). Repeat this step to attach the other axle to the
opposite side.
fIGUrE 6
STEp 7: (SEE fIGUrE 7)
1.
Attach the tongue assembly to the wheel support
using the channel pivot pin (Q) and a 3/32" hair cotter
pin (S).
fIGUrE 7
5
H
B
Q
S
9
Publicité
Table des Matières
