Rowenta AQUA EXCEL Mode D'emploi page 12

EN
ATTENTION Leave the foam material to dry completely: motor protection filter before
replacing it in the appliance (fig. 15).
3 • CHANGING THE PROTECTION FOAM MATERIAL OF THE MOTOR
Always unplug the appliance.
Unlock the holding tabs and take out the motor unit and then the protection foam material of the
motor*.
Clean the permanent filter* by taping it (fig. 14). You can wash it or tap it. See & cleaning the foam ma-
terial. Change the filter when the suction capacity drops or if it is damaged.
4 • CLEANING THE FOAM MATERIAL FILTER OF THE AIR OUTLET
Always unplug the appliance.
Wash the foam material filter every 5 paper bags changes approximately or every year. Remove the
grille in the back to release the foam material filter (fig. 16). Check the state of the foam material filter
and wash it.
5 • CHANGING THE BLOWING CASSETTE
Always unplug the appliance. Press the 2 straps and take out the cassette (fig. 17).
Remove the back grille of the cassette to release the foam material filter.
Check the state of the foam material filter and wash it every 5 paper bags changes approximately or
every year. Remove the foam material filter fixed on the grille (fig. 17) and wash it with water and mild
detergent. Rinse, dry well and put it back in its place.
Reassemble the blowing cassette and replace it into the appliance (fig. 18).
ATTENTION Leave the foam material filter to dry completely before replacing it in the appliance. Ensure
that the foam material filter is well dried before replacing it in the appliance .
6 • CLEAN YOUR VACUUM CLEANER
Wipe the body of the appliance and the attachments with a soft and wet cloth then dry with a dry cloth.
IMPORTANT Do not use detergents, aggressive or abrasive products.
REPAIRS
IMPORTANT As soon as your vacuum cleaner works less well and before any verification, stop it by
pressing the On-off switch.
If your vacuum cleaner does not start
• The appliance is not powered. Verify if the appliance is correctly connected.
If your vacuum cleaner does not suck up
• An attachment or the hose is blocked: unblock the attachment or the hose.
If your vacuum cleaner sucks up less well, makes a noise, whistles
• An attachment or the hose is partially blocked: unblock the attachment or the hose.
If you encounter difficulties in moving the nozzle
• Open the power mechanical speed variator* to the stick.
The bag* is full or saturated with fine dust:
• Change the bag.
The power mechanical speed variator* to the stick is opened:
• Close the power mechanical speed variator.
* Depending on the model: equipment specific to certain models or attachments available as option.
9