Unpacking And Checking The Package Contents; Preparation; Before First Use - Steinbach CPS 40-2 Notice D'utilisation

Improper handling of the device can damage the device.
- Select a location for the device that is protected from the weather.
- Ensure sufficient air exchange to prevent overheating of the motor.
- Do not let the device run dry (without water).
- Never place the device or parts of it in the pool.

Unpacking and checking the package contents

Packaging materials pose a risk of suffocation!
Catching your head in the packaging foil or swallowing other packaging materials can cause
death. There is a higher risk for children and mentally challenged persons who cannot
estimate the hazard potential due to lack of knowledge and experience.
- Prevent children and mentally challenged persons from playing with the packaging
materials.

Preparation

Choosing the location
The pump is sufficiently protected against water and foreign objects entering the pump.
However, a location that is protected from severe weather influences also reduces dirt
build-up and wear.
The following requirements must be met or considered:
- Position the pump between the suction connection and the injection nozzle with sufficient distance
to the pool wall so that the pump cannot be used to climb into the pool.
- Position the pump below the water level.
- The maximum distance to the pool is 3 m (8 ft.).
- The surface, for example a concrete slab, must be stable, sturdy and horizontal.
Description
Description of the filter pump
The filter pump pumps the pool water from the pool to the filter system.
Filtering time
The pool's water content should be circulated at least twice in a 24 h period. In case of heavier
frequency, the pool water should be circulated 3 to 5 times per day.

Before First Use

Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
- Never operate water treatment system devices while persons are in the pool.
- Prevent any access to the pool for as long as water treatment system devices are in use.
Check the following before start-up
- The device is out of the pool and the power cable is disconnected from the mains
NOTICE!
WARNING!
WARNING!
19