ION AquaSport Max Guide D'utilisation page 9

Troubleshooting
If the unit is not charging: Make sure the power cable is properly connected to the power
input and the power outlet.
If the sound is distorted: Try lowering the volume control of your sound source.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If you cannot connect your audio device to AquaSport
•
Have your audio device (e.g., smartphone or tablet) and AquaSport
together as possible while trying to connect. Make sure both the audio device and
™
AquaSport Max are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on AquaSport
any other audio device and restart the search process. If this does not work right away,
power off AquaSport
Device for more information.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back
on. You can find this under the Bluetooth menu in the Settings for your phone or other
audio device.
If this does not work, and you have connected to AquaSport
™
AquaSport Max in the list of available or previously connected devices in your audio
device's Bluetooth menu, tap the "gear" or "i" icon located next to it and then select
Unpair or Forget. Turn AquaSport
reappears in your available devices list.
Note: If AquaSport
within range, you may need to repeat this process with that audio device to fully
disconnect.
If you experience audio dropouts while playing music from a Bluetooth device, this may
be happening because your unit is trying to link to another speaker. This can occur if you
power off a speaker that was linked to your unit or if you have just turned on your unit and it is
in Stereo-Link mode. To stop the audio dropouts, exit Stereo-Link mode by double-pressing
the Bluetooth button. Alternatively, you can wait for your unit to link to another speaker if
there is one within range.
If there is a delay in the audio signal between the left and right speakers when linked,
break the link by double-pressing the Link button, and pair them again following the
instructions in the Linking Two AquaSport
If you would like to stop your speaker from automatically linking when you power it on,
make sure you double-press the Bluetooth button to exit Stereo-Link
power it off.
™
Max and then power it back on. See
™
Max off and back on and try pairing again once it
™
Max has been paired to another audio device recently that is still
™
™
Max via Bluetooth:
™
Max to disconnect AquaSport
Max Speakers section.
9
™
Max as close
™
Max from
Pairing with a Bluetooth
™
Max before, find
™
mode before you