Using The Radio - ION AquaSport Max Guide D'utilisation

Smart Connect to a Smart Assistant
1. Connect a device via Bluetooth.
2. Press and hold Play/Pause on AquaSport
send a message to the connected Bluetooth device to trigger its native smart assistant to
listen for a spoken command. If music is playing at the time, it will be paused. To cancel,
press and hold Play/Pause.
3. Speak commands in a normal volume within 1 meter away from AquaSport
microphone.
Note: If a command is not spoken, the smart assistant will stop listening per the device's
native settings (e.g. Siri stops around 6 seconds), and exit Smart Connect mode. If music
was playing before prior to Step 2, the music will un-pause and continue to play.
4. After the smart assistant has spoken a reply, AquaSport
mode. If music was playing prior to Step 2, the music will un-pause and continue to play.

Using the Radio

1. Press the Radio button.
2. Select a radio station by pressing and holding the + or - button.
3. To scan through all stations, hold down the Radio button for 2 seconds. To stop scanning,
hold the Radio button for 2 seconds.
Note: The last radio station the radio was tuned to when powering off will be the first
station the radio will tune to when powering back on.
To save a preset station, use the ION Sound XP
To recall a preset station, press and release Play/Pause to advance through one of the 6
presets.
Connecting an Audio Device Using the Aux Input
1. Connect a 1/8" (3.5 mm) auxiliary cable to the input on the rear panel of AquaSport
and connect the other end to an audio device such as an MP3 or CD player. The speaker
will automatically switch the audio source to Aux mode but will maintain all Bluetooth
connections.
2. Press play on your device's music player. Use the Volume Up/Down buttons to adjust the
Aux volume.
Note: AquaSport
device. Lower the volume on your device if signal distortion occurs.
Disconnect the Aux cable to exit Aux mode. AquaSport
3.
it was in before the Aux connection, Bluetooth or Radio.
™
Max speaker volume controls act independently from your connected
™
Max to enter Smart Connect mode. This will
™
Max will exit Smart Connect
™
app.
™
Max will revert to the audio mode
7
™
Max's
™
Max