Briteq BT-PROFILE160 LED Mode D'emploi page 8

ENGLISH
Firmware version (Ver.)
Shows the actual version of the controller.
 Press the MENU-button (2) until the display shows "Ver."
 The display shows the actual firmware version.
Dimmer behavior (DimCurve)
Used to select the behavior of the dimmer (dimmer curve).
 Press the MENU-button (2) until the display shows "DimCurve"
 Press the UP/DOWN buttons (3) to select one of the 4 available curves (see drawings):
 Linear (Mode 1): light output varies linearly with the dimmer value
 Square (Mode 2): light output can be adjusted more accurately for low dimmer values
 InvSquare (Mode 3): light output can be adjusted more accurately for high dimmer values.
 S-Curve (Mode 4): light output can be adjusted more accurately for both high and low dimmer values.
 Press the ENTER button (4) to confirm.
Some extra safety remarks:
 Always unplug the unit when it is not used for a longer time or before to start servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 Important: Never look directly into the light source! Don't use the strobe function in the presence of
persons suffering from epilepsy.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and
should be replaced immediately when even a small
problem is detected.
 In order to protect the device from overheat the cooling
fans and ventilation openings should be cleaned
monthly.
 The interior of the device should be cleaned periodically
using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses
must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly
dirty surroundings can cause greater accumulation of
dirt on the unit's optics.
 The lens compartment can be opened for easy access to the lenses, see picture: turn the small
silver knob (***) to unlock the cover that closes the lens compartment and open it.
 Clean the lenses inside with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
BRITEQ
®
6/35
OPERATION MANUAL
BT-PROFILE160 LED