Optional Accessories - Jet JWDS-2244-M Mode D'emploi

Symptom
Snipe marks.
Sander burns wood.
Board slips on conveyor
belt.
Ripples in sanded surface.
A. Non‐uniformly spaced
ripples.
B. Uniformly spaced
ripples.
Wood is gouged.
* WARNING: Some corrections may require a qualified electrician.
14.0 Optional accessories
For JWDS‐2244‐M:
98‐0130 Locking Casters for Open Stand, set of 4
723541 Folding Infeed/Outfeed Tables for JWDS‐2244‐M
723552 Digital Read Out
723553 Depth Stop Assembly
For JWDS‐2550‐M:
723550OS Open Stand for JWDS‐2550‐M
98‐0130 Locking Casters for Open Stand, set of 4
723544CS Closed Stand for JWDS‐2550‐M
723551 Folding Infeed/Outfeed Tables for JWDS‐2550‐M
723552 Digital Read Out
All manuals and user guides at all-guides.com
Possible Cause
Improper tension on rollers.
Abrasive strip is overlapped.
Abrasive is loaded.
Depth of cut excessive for fine grit.
Feed rate too slow.
Abrasive is worn.
Tension rollers too high.
Excessive feed rate.
Dirty or worn conveyor belt.
A. Uneven feed rate.
B. Conveyor table flexing or vibration.
Stock slipping on conveyor.
Work piece not properly supported.
Table 3
Correction *
Re‐tension rollers.
Re‐wrap abrasive strip.
Clean abrasive.
Use coarser grit or reduce depth of cut.
Increase feed rate.
Replace abrasive.
Lower tension rollers.
Reduce feed rate.
Replace conveyor belt.
Conveyor belt slipping (see above)
Board slips on conveyor belt (see above).
Conveyor motor stalls (see above).
Reduce depth of cut and/or feed rate. Check for
loose bolts, loose shaft coupling set screws, or
out‐of‐balance drum.
Correct depth of cut or roller tension.
Add work supports for long work pieces.
21