Operation - ROBLIN ATRIUM.5 Notice

GB
IN THE EXTRACTION MODE:
a. Fig. 8 Fit the non-return backflow flaps (C) over the round outlet (6) on top of the canopy while
pressing down until they snap into position, and then connect the ducting 150mm (6 INS).
IN THE RECIRCULATION MODE:
a. Fit the recirculation spigot (R) onto the chimney bracket using the same fixing screws Fig. 6a;6b .
b. Connect the ducting 150mm (6 INS) not provided (T) Fig. 7 between motors (6) and the recirculation
spigot
c. Place the top chimney with the slops fac-ing upwards Fig. 6c (7a) when installing the
recirculation version
S ecure the connections with appropriate clamping rings or adhesive tape Fig. 6c.
7)
Make the electrical connection as described in the section titled ELECTRICAL.
8)
Each top and lower chimney stack consists of two sections. Place the top chimney with the slops fac-ing
9)
upwards Fig. 6c (7a) when installing the recirculation version and secure the chimney stacks to the
brackets using the M4 screws provided Fig. 2a.
10) Place the lower chimney (7b) as illustrated in Fig. 10.
• FITTING THE CANOPY ONTO THE CHIMNEY
Check the connectors of the motor as illustrated Fig. 11 .
11)
Test the lights and the fan motor.
12)
Remove the metal grease filters. Insert the charcoal filter into the base of the motor housing
13)
and secure the filter with two securing straps (A) as illustrated Fig. 6d.
14) Fit the metal grease filters.
4 4

OPERATION

A - EXTRACTION OR RECYCLING :Your cooker hood is supplied in the extraction mode. To use the cooker
hood in the recycling mode re-programme the hood as follows:
Starting in the recycling mode (the contaminated air passes into the hood through the grease filters and
the purifying activated charcoal filter and back out into the kitchen through grilles).
Press the '+' button (while the motor and lights are switched 'OFF') until the five LED lights will flash twice
to indicate confirmation that the cooker hood is in the recycling mode.
7
8