Cleaning & Maintenance; Possible Causes - Bosch TDS25 Serie Notice D'emploi

en
5. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To
obtain the best result, we recommend that this
operation is done twice
6. Important: before re-closing, make sure no water
remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin
Intelligent steam
This ironing system has intelligent steam control,
which provides additional steam depending on the
user demand.
Cleaning & Maintenance
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
Trouble shooting
Problem

Possible causes

The steam generator • There is a connection problem.
does not come on.
• The steam tank and/or main power
button is not switched on.
The iron does not • The main power button is not
heat up. switched on.
• The temperature control knob is set
to the «min» position.
The iron begins • During first use: Certain components
to smoke when on the appliance have been lightly
switched on. greased at the factory and may
produce a little smoke when initially
heated.
• During later use: the soleplate may
be soiled.
Water flows through • The steam function is being used
the holes on the sole before it has reached temperature.
plate.
• The water is condensing inside the
pipes because steam is being used
for the first time or has not been
used for a long time.
14
All manuals and user guides at all-guides.com
3. If the soleplate is soiled with dirt or scale, clean
4. Never use abrasive products or solvents.
Important:
• Always unplug the appliance from the mains
Storing the appliance (D)
1. Always allow the appliance to cool down before
2. Set the switches for main power and steam
3. Place the iron on the iron pad, standing on the
4. Empty the water tank and store the mains cable
it with a damp cloth.
supply before carrying out any cleaning or
maintenance operation on it.
storing it.
boiler to the «Off/Stop» position and disconnect
the connection.
soleplate.
on the cord rewind facility. Tidy the steam hose
on the handle of the iron using the cord clip
provided (12). Do not wrap the cords too tight.
Solution
• Check the mains cable, the plug and
the socket.
• Press the buttons for main power (6)
and steam tank (4) «On/Start».
• Press the main power button (6) «On».
• Set the temperature control knob (13)
to the desired position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures (Variable steam
control (3)).
• Point the iron away from the ironing
area and press the steam release
button (15) until steam is produced.