Cleaning & Maintenance - Bosch I2 Série Notice D'utilisation

Cleaning & Maintenance
3x
min min
1
2x
22
B O SC H
1. Descaling process
This appliance is equipped with an automatic clean
warning indicator, which indicates that scale
particles must be removed from inside the steam
chamber.
When activated, three beeps will be heard, and the
"Calc'nClean" indicator light (7) will flash indicating
that the process should be performed.
You may continue ironing for a time. Once this time
has passed, you will only be able to dry iron (without
2"
steam).
To start steam ironing again, follow this descaling
process:
1 Fill the tank (11) with tap water.
2 Plug in the mains cable (9) and press "on/off" button
2"
(5) to switch the appliance on.
3 Press the descaling button (6) for 2 seconds.
The "Calc'nClean" indicator light (7) will remain
permanently lit and a beep will be heard.
4 Wait until one of the indicator lights (2,3,4) stops
flashing and remains lit permanently. Two beeps will
be heard.
5 Place the iron on the "Calc'nClean" container (19).
Make sure that the surface on which the container is
placed is stable.
Warnings:
• Do not remove the iron from the container until
the process has finished. Boiling water and steam
will be released through the soleplate, removing
limescale and/or deposits that may be inside.
• The container must only be used the to perform the
descaling process. It must not be used as a stand
for the iron while ironing.
* Model dependent