Important; Setting The Temperature - Bosch TDS25 Serie Notice D'emploi

en
8. "Water empty" pilot light
9. Housing with internal steam generator
10. Mains plug
11. Mains cable with storage facility
12. Cord clip
13. Temperature dial
14. Iron pilot light
15. Steam release button
16. Soleplate
17. Steam gun
18. Steam release button
19. Steam concentrator
20. Brush extension
21. Diffuser extension
22. Accessorie box
23. Protection cap
24. Slot position for connection
Preparations (A)
1. Remove any label or protective covering from the
soleplate.
2. Place the appliance horizontally on a solid, stable
surface. You may remove the iron pad from the
appliance and place the iron on it on another
solid, stable, horizontal surface.
3. Remove the detachable water tank and fill it,
making sure not to pass the level mark.
4. Fit the water tank back onto the steam tank.
5. Unwind the mains cable fully and plug it into an
earthed socket.
6. Set the boiler «Start/Stop» button (4) and main
power «On/Off» button (6) switches to the
«Start/On» position.
7. The green «steam ready» indicator lamp (7) will
light up after approximately 5 minutes, indicating
that the appliance is ready to use.
8. This appliance has a built-in water level sensor.
The red «refill water tank» indicator (8) will light
when the water tank is empty.

Important:

• Normal tap water can be used.
To prolong the optimum steam function, mix tap
water with distilled water 1:1. If the tap water
in your district is very hard, mix tap water with
distilled water 1:2.
You can inquire about the water hardness with
your local water supplier.
12
All manuals and user guides at all-guides.com
• The water tank can be filled at any time while
• To avoid damage and/or contamination of the
• The iron pad (2) can be placed into the specially
• During it first use the iron may produce certain
• While the steam release button is pressed, the

Setting the temperature

1. Check the ironing instruction label on the garment
2. Select the temperature (13)
3. The indicator lamp (14) will remain lit while the
Tips:
• Sort your garments out based on their cleaning
• If you are not sure what the garment is made
Ironing with steam (B)
1. Make sure that there is enough water in the
2. Turn the temperature selector to the steam
3. Set the amount of steam to suit your needs,
using the appliance.
water tank, do not put perfume, vinegar, starch,
descaling agents, additives or any other type of
chemical product into the water tank.
designed recess on the appliance or somewhere
suitable alongside the ironing area.
Never rest the iron on the appliance without the
iron pad!.
vapours and odours, along with white particles
on the soleplate, this is normal and it will stop
after a few minutes
water tank may produce a pumping sound, this
is normal, indicating that water is being pumped
to the steam tank.
to determine the correct ironing temperature.
«•» Synthetics
«••» Silk – Wool
«•••» Cotton – Linen
iron is heating and go out as soon as the iron has
reached the selected temperature.
symbol labels, always starting with clothes that
have to be ironed at the lowest temperatures.
of then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn
water tank
position, between «••» and «max».
using the variable steam control (3)