Kenwood FDP65 Instructions page 8

Before using your appliance refer to the separate safety
warning leaflet and read the instructions for usage contained
in this manual carefully. Retain for future reference.
Before plugging in
Make sure your electricity supply is the same as the one shown on the underside of your appliance.
This appliance conforms to EC Regulation 1935/2004 on materials and articles intended to come into
contact with food.
Before using for the first time
1 Remove the plastic blade covers from the knife blade. Take care the blades are very sharp. These
covers should be discarded as they are to protect the blade during manufacture and transit only.
2 Wash the parts see 'Care and Cleaning'.
Key
Processor - Express Prep
Pushers
1
Feed tube
2
Lid
3
Bowl
4
Detachable drive shaft
5
Power unit
6
Speed/pulse control
7
Safety interlocks
8
Cord storage (at back)
9
Plastic Blender
10
a
Goblet with fixed blade
b
Lid with drip feed
A Standard Attachments
Knife blade
11
Dough tool
12
Emulsifying disc
13
4mm slicing/grating disc
14
2mm slicing/grating disc
15
Not all of the attachments listed below may be
included with your food processor. Attachments
are dependent upon the model variant. Visit
www.kenwoodworld.com for information on how
to buy an attachment not included in pack.
B Optional Attachments
Extra fine grating disc (if supplied)
16
Citrus juicer (if supplied)
17
Mini chopper/mill (if supplied)
18
Grinding mill (if supplied)
19
Blend-Xtract 2GO (if supplied)
20
Juice extractor (if supplied)
21
Express Dice (if supplied)
22
Express Serve (if supplied)
23
Storage bag (if supplied)
24
Spatula
25
English
To Use Your Food Processor
Illustrations
1 Fit the detachable drive shaft onto the power
unit.
2 Then fit the bowl to the power unit and turn
clockwise until it locks into position.
3 Fit an attachment over the bowl drive shaft.
Always fit the bowl and attachment onto the
processor before adding ingredients.
4 Fit the lid - ensuring the top of the drive
shaft/tool locates into the centre of the lid.
Do not use the lid to operate the processor,
always use the on/off speed control.
5 Plug in, switch on and select a speed. (Refer
to the recommended usage chart).
The processor will not operate if the bowl
or lid are not fitted correctly into the
interlock. Check that the feed tube and
bowl handle are situated to the right front
hand corner.
Use the pulse (P) for short bursts. The pulse
will operate for as long as the control is held
in position.
6 Reverse the above procedure to remove the
lid, attachments and bowl.
Always switch off and unplug before
removing the lid.
Important
Your processor is not suitable for crushing
or grinding coffee beans, or converting
granulated sugar to caster sugar.
When adding almond essence or flavouring
to mixtures avoid contact with the plastic as
this may result in permanent marking.
2
09
–