TSI Q-Trak XP 7585 Guide De Démarrage Rapide page 2

Thank you for purchasing a TSI
Q-Trak™ XP Indoor Air Quality (IAQ) Monitor. This guide
will help you quickly begin using your monitor.
More detailed information is in the Operation Manual
located on the included Q-Trak™ XP USB Flash Drive.
Please refer to the manual if you have questions on the
operation of your new monitor.
Safety
Refer to the Q-Trak™ XP Indoor Air Quality Monitor
Mode 7585 user manual for safety information.
The instrument must be used in the
manner described in the user manual.
Failure to follow all of the procedures
described in the manual can result in
serious injury to you or can cause
irrevocable damage to the instrument.
Unpacking and Parts
Identification
Carefully unpack the instrument and accessories from the
shipping container. Check the individual parts against the
list of components below. If anything is missing or
damaged, notify TSI ® immediately. All standard equipment
can be purchased separately if needed.
Part No. Description
7585 Includes Q-Trak™ XP Base
Meter 7580, Multi-Sensor
IAQ Module 801430 and
Carbon Dioxide (CO
801399
Base Meter only – Handle
7580
portion
CO (Carbon Dioxide), NDIR
801399
2
(Nondispersive Infrared
sensor)
801430 IAQ Multi-Sensor Gas
Module with Built-in Sensors:
Particulate Matter,
Temperature, Relative
Humidity and Barometric
Pressure
® ®
Incorporated (TSI )
W A R N I N G
Picture
) sensor
2
Part No. Description
800121 Carrying Case
Lithium Ion Rechargeable
800123
Battery Pack
804001 USB Cable
800122 AC Adapter/Power Supply
Q-Trak™ XP IAQ Monitor
6013908
Quick Start Guide
800120 Gas Sensor Calibration Cap
7004035 USB Flash Drive with
Q-Trak™ XP manuals and
other literature.
Installation of Gas Sensors
In addition to the standard built-in sensors, the device can
accept up to six gas sensors.
Install the gas sensors as follows:
1. Ensure the instrument is powered OFF.
2. Remove the sensor module cover.
-2-
Picture