AEG FAVORIT 55522WO Notice D'utilisation page 35

All manuals and user guides at all-guides.com
With some problems, the display shows
an alarm code.
Problem and alarm code
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The display shows
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem
There are whitish streaks or bluish layers on
glasses and dishes.
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no a damage fuse in the fuse
box.
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance has started the procedure to re-
charge the resin inside the water softener. The dura-
tion of the procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
.
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog-
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
.
• Close the water tap and contact an Authorised Serv-
ice Centre.
.
Possible solution
• The release quantity of rinse aid is too
• The quantity of detergent is too much.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
much. Adjust the rinse aid selector to a
lower position.
ENGLISH 35