Yamaha DVD-S663 Mode D'emploi page 47

Problem
No picture is displayed when
you do not use progressive
scan connections (using the
component video jacks)
Completely distorted picture,
black/white picture, or no
picture
Distorted picture
Picture freezes momentarily
during playback
HD JPEG pictures cannot be
displayed
The screen size looks
unnatural, or the caption is
displayed only partially on the
TV monitor or is not displayed
at all
No sound or distorted sound
No audio at digital output
No sound during DivX
playback
This unit does not respond to
the remote control
Follow the steps below to turn off the progressive scan.
1. Press OPEN/CLOSE (
7
on the remote control to open the disc tray.
2. Press 2 on the remote control.
3. Press ZOOM on the remote control to deactivate the progressive
scan.
Check that the disc is compatible with this unit (see "Playable disc
formats" on page 4).
Check that the TV type of this unit is set to match that of the disc and
your TV (see "Setting a color system for your TV" on page 14). Follow
the steps below to change the setting of [TV TYPE].
1. Press OPEN/CLOSE (
7
on the remote control to open the disc tray.
2. Press 3 on the remote control.
3. Press AUDIO on the remote control.
Occasionally, a small amount of picture distortion may appear
depending on the disc being played back. This is not a malfunction.
Check the video connection.
Check the disc for fingerprints/scratches and clean it with a soft cloth
wiping from center to edge.
For WMV/DivX
Check that [HD JPEG] is set to [ON] (see page 37).
The disc reading time may exceed 30 seconds.
MP3 music and HD JPEG pictures cannot be played simultaneously.
Check that the TV setting of this unit matches the screen size of your
TV (see "Setting the TV display" on page 33).
Change the screen size and the aspect ratio of your TV.
Adjust the volume.
Check that the speakers are connected correctly.
Check the audio connection.
For MP3/WMA, check that the sampling rate and bit rate are
compatible with this unit (see "Specifications" on page 48).
For WMV/DivX
bit rate.
Check the digital connections.
If you are playing a DTS source, check that your receiver can decode
DTS, and that [DIGITAL OUTPUT] is set to [ALL] (see page 32).
Check that the audio format of the selected audio language matches
your receiver capabilities.
®
movie The audio code may not be supported by this unit.
Aim the remote control directly at the remote control sensor on the front
panel.
Reduce the distance of the remote control from this unit.
Replace the batteries in the remote control.
Reinsert the batteries with their polarities (+/– signs) as indicated.
Troubleshooting
Solution
) on the front panel or press and hold
) on the front panel or press and hold
®
, lowering the bit rate may improve the problem.
®
, record the file onto your USB device at a lower
43
En